Modern Problems of Metallurgy

Articles

• Investigation of the parameters influence of a cylindrical inductor with two-layer inwall on its temperaturePhysico-chemical prerequisites for decarburization of carbon-thermal reduction products Cr2O3

  A. Grishin, A. Nadtochij, V. Petrenko, V. Kyrychok

  3-16

• Design and analysis of circuit technique of inverter converter for induction heating

  A. Zimoglyad, A. Guda, N. Kalinina, V. Balakin, H. Larionov

  17-34

• Mathematical foundations of fractal heat and mass transfer in the two-phase zone of the metal melt

  T. Selivyorstova, V. Selivyorstov, L. Yvanova

  35-44

• Investigation of deformation zone parameter at multichannel angular extrusion

  Yu. Zubko, Ya. Frolov, O. Kuzmina, A. Samsonenko, O. Bobukh

  45-59

• Assessment of using shungite rock technological feasibility in the production of manganese agglomerate

  L. Kamkina, Ya. Mianovska, Yu. Projdak, A. Mishalkin

  60-74

• Possibilities of reducing electricity consumption by ore-thermal furnace

  Yu. Kachan, V. Mishchenko

  75-84

• Skin-rolling of hot-rolled extra-thin low-carbon steel sheets

  V. Kutzova, V. Ivanchenko, T. Kotova, M. Kovzel

  85-92

• Modeling of the influence of the chemical composition and structure on the mechanical properties of alloy rolled products

  V. Lutsenko, T. Golubenko, I. Chuiko, O. Lutsenko

  93-101

• Stabilization of the radial clear in the pumping assembly of the supply pump improvement by improving the structure of the slide bearing bushing

  P. Melyantsov, O. Losikov, V. Nazarets, V. Sidorenko

  102-116

• Modeling of blast furnace melt processes when changing the program of charging the burden

  O. Merkulov, Yu. Semenov, M. Dzhigota

  117-125

• Thermodynamical analysis of technological operation of parallel and silicon removing from the cast iron

  L. Molchanov, M. Pushkarenko, V. Kislyakov

  126-135

• Performance evaluations research of multiprocessor system in the problem of heat treatment of metal products

  D. Moroz

  136-149

• Methods of recycling of lithium power sources

  V. Skosar, S. Burylov, O. Voroshilov, Yu. Zhulay, V. Dzenzersky

  150-163

• Some aspects of modeling of technical diagnostics of mechanisms

  L. Sushko

  164-182

• RESEARCH OF METHODS FOR MEASURING THE PHYSICAL PARAMETERS OF THE FLUE GAS POSTCOMBUSTION TORCH IN OXYGEN CONVERTER

  Tetiana Golub , Lavr Molchanov , Sergiy Semykin

  183-191

• EXPERIMENTAL STUDY OF THE MOTION OF VIBRATING SCREEN ELEMENTS WITH ELASTIC DYNAMICALLY ACTIVE SURFACE

  Dmytro Kononov , Viktor Yermokratiev , Volodymyr Chechenev

  192-200

• STUDY OF CHANGES OF THE SULFUR CONTENT IN CAST IRON AND THE COMPOSITION OF SLAG IN TECHNOLOGICAL PROCESSING DURING THE PREPARATION OF CAST IRON FOR THE CONVERTER MELTER

  Shevchenko Anatoliy, Volodymyr Kislyakov , Borys Dvoskin , Ivan Manachyn , Kostyantin Chubin

  201-219