CAD/CAE-СИСТЕМИ ЯК НАВЧАЛЬНЕ СЕРЕДОВИЩЕ ІНЖЕНЕРА

Автор(и)

  • О.Ю. Рудик

Ключові слова:

3D ПРОЕКТУВАННЯ, SOLIDWORKS, ІНЖЕНЕРНИЙ АНАЛІЗ, SOLIDWORKS SIMULATION, МОДЕЛЮВАННЯ

Анотація

The questions of engineering analysis by a computer-aided design are lighted up SolidWorks and its appendixes SolidWorks Simulation. The physical processes that characterize the stress-strain state of the crosspiece of the device for cross compression of the bar are considered. The maximum nodal stresses and the resulting displacements have a minimum margin of safety. The conclusion of the conducted research is the following: under the action of applied forces in the extreme case the crosspiece is on the verge of destruction. Therefore, it is necessary to either replace the material of the crosspiece with a stronger one or apply heat treatment to the existing one.

Посилання

1. Rudyk O. Yu. SolidWorks application in training of subjects of technical (engineering) cycle [Electronic resource] / O. Yu. Rudyk, V. V. Gerasimchuk. – Access mode: http://elar.khnu.km.ua/jspui/handle/123456789/8713
2. Rudyk O. Yu. Investigation of the strength of car parts by SolidWorks Simulation [Electronic resource] / O. Yu. Rudyk, G. V. Sadovskyi. – Access mode: http://ir.lib.vntu.edu.ua/handle/123456789/11682
3. Korolev Yu. I. Engineering and computer graphics. Tutorial. The third generation standard / Yu. I. Korolev, S. Yu. Ustyuzhanina. – St. Petersburg: Peter, 2014. – 432 p.

Завантаження

Опубліковано

2020-03-25

Номер

Розділ

Статті