STRUCTURE AND PROPERTIES OF THIN SHEET STEEL 08ПС AFTER SKIN-ROLLING
Keywords:low-carbon steel, hot-rolled sheet steel, skin-rolling, mechanical properties, plasticity
The requirements of standards for quality indicators of rolled products are increasing. Relevant is the saving of operating costs in the manufacture of a thin sheet. Skin rolling is one of the key operations in the technological process of production of hot-rolled sheets for cold stamping. In order to improve the quality of thin-sheet rolled products, it is important to develop an effective skin rolling technology. In this work, the structure and properties of hot-rolled thin-sheet low-carbon steel 08пс after skin pass at a separately located mill are studied. It is shown that as a result of processing, the plasticity of the metal increases and a uniform structure is formed over the sheet section. It has been established that hot-rolled sheet metal in terms of quality meets the requirements for cold-rolled products in accordance with ДСТУ 2834-94. It is possible to replace an expensive cold-rolled sheet with a cheaper, but of the same quality, hot-rolled sheet. As a result, an increase in labor productivity, a decrease in the metal consumption coefficient, and savings in electricity and natural gas are achieved.
Yu.M. Koval, V.Z. Kutsova, T.V. Kotova, M.A. Kovzel Forecasting and controlling the structure and properties of ultra-low-carbon steels / Metallophysics and Advanced Technologies, 2021 – vol. 43, р.р. 753-768. – ISSN1024-1809 (Print) E-ISSN: 2617-1511 (Online).
Alloy steels and alloys with special properties. Textbook / Kutsova V. Z., Kovzel M. A., Nosko O. A. - Dnepropetrovsk: NMetAU, 2008. - 348 p.
Zlov V.E. Production of hot-rolled strips with consumer properties corresponding to cold-rolled strips / V.E. Zlov, A.P. Budanov, A.I. Cherkassky // Steel. - 1997. - No. 6. - P. 53.
Sheet steel: Monograph / Yu. S. Proydak, V. Z. Kutsova, M. A. Kovzel, T. V. Kotova,
G. P. Stetsenko / Dnipro: NMetAU, 2018. - 311 p. – ISBN 978-617-7696-51-2.
Frantsenyuk I.V. Rolled sheets of different levels of plasticity and strength for cold stamping / I.V. Frantsenyuk, L.I. Frantsenyuk, S.S. Kolpakov, A.P. Konshin, V.G. Ivanchenko, E.S. Kakushkin // Steel. - 1991. - No. 12. - P. 42 - 45.
Frantsenyuk L.I. Some features of the production of hot-rolled pickled sheet metal for cold stamping / L.I. Frantsenyuk, V.G. Ivanchenko // Metallurgical and mining industry. - 1993. - No. 3. - P. 25-27.